Design optimization and electrical performance improvement of tritium-based nuclear batteries
Journal of Radiation Research and Radiation ProcessingVol. 41, Issue 6, Pages: 60701(2023)
作者机构:
1.苏州热工研究院有限公司 苏州 215004
2.国家核电厂安全及可靠性工程技术研究中心 苏州 215004
3.南京航空航天大学核科学与技术系 南京 211106
作者简介:
YING Hong (male) was born in August 1987, and obtained his master's degree from University of Science and Technology of China in 2011, senior engineer
TANG Xiaobin, professor, E-mail: tangxiaobin@nuaa.edu.cn
基金信息:
National Natural Science Foundation of China(12005101);the Fundamental Research Funds for the Central Universities(NT2023013);the Excellent Postdoctoral Program of Jiangsu Province(2022ZB235)
YING Hong, SHI Haining, LIANG Dongdong, et al. Design optimization and electrical performance improvement of tritium-based nuclear batteries[J]. Journal of Radiation Research and Radiation Processing, 2023, 41(6): 060701.
YING Hong, SHI Haining, LIANG Dongdong, et al. Design optimization and electrical performance improvement of tritium-based nuclear batteries[J]. Journal of Radiation Research and Radiation Processing, 2023, 41(6): 060701. DOI: 10.11889/j.1000-3436.2023-0047.
Design optimization and electrical performance improvement of tritium-based nuclear batteries
The performance of tritium-based nuclear batteries based on two different energy conversion modes, the irradiated voltaic effect and irradiated photovoltaic effect, was studied by using the Monte Carlo method. The influence of the geometrical-physical parameters of energy conversion materials on the electrical output performance of batteries wais investigated. Single-layer and stacked-layer tritium-based nuclear batteries were designed and prepared. The effects of increasing the tritium source intensity and adopting the stacked-layer configuration on the enhancement of the electrical output of the batteries were analyzed. The simulation results showed that Si, SiC, and GaAs photovoltaic modules could be used for irradiated voltaic effect tritium-based nuclear batteries and that their respective optimal thickness parameters allow the electrical output performance to be optimized; the optimal thicknesses were 3.8 μm, 2.2 μm, and 1.7 μm, respectively. For irradiated photovoltaic effect tritium-based nuclear batteries, the thickness of the ZnS:Cu fluorescent layer could be adjusted to maximize the emitted fluorescence irradiance and optimized the electrical output performance. The experimental results showed that increasing the radiation intensity of the tritium source and adopting the stacked-layer configuration could effectively enhance electrical parameters such as the maximum output power of tritium-based nuclear batteries. The maximum output power of the stacked-layer nuclear battery could reach 106.138 nW, which was an increase of more than 64% compared with that of the single-layer configuration.
关键词
同位素电池氚蒙特卡罗方法辐致伏特效应辐致光伏效应
Keywords
Nuclear batteryTritiumMonte Carlo methodIrradiated voltaic effectIrradiated photovoltaic effect
ZHOU Yi, ZHANG Shixu, LI Gongping. A review of radioisotope batteries[J]. Chinese Science Bulletin, 2017, 62(17): 1831-1845. DOI: 10.1360/N972016-00793http://dx.doi.org/10.1360/N972016-00793.
Li H, Liu Y B, Hu R, et al. Simulations about self-absorption of tritium in titanium tritide and the energy deposition in a silicon Schottky barrier diode[J]. Applied Radiation and Isotopes, 2012, 70(11): 2559-2563. DOI: 10.1016/j.apradiso.2012.07.012http://dx.doi.org/10.1016/j.apradiso.2012.07.012.
Russo J, Litz M, Ray W, et al. Development of tritiated nitroxide for nuclear battery[J]. Applied Radiation and Isotopes, 2017, 125: 66-73. DOI: 10.1016/j.apradiso. 2017.04.013http://dx.doi.org/10.1016/j.apradiso.2017.04.013.
Russo J, Litz M, Ray W, et al. Demonstration of a tritiated nitroxide nuclear battery[J]. Applied Radiation and Isotopes, 2019, 144: 93-103. DOI: 10.1016/j.apradiso.2018.10.012http://dx.doi.org/10.1016/j.apradiso.2018.10.012.
Russo J, Litz M S, William Ray I I, et al. Planar and textured surface optimization for a tritium-based betavoltaic nuclear battery[J]. International Journal of Energy Research, 2019, 43(9): 4370-4389. DOI: 10.1002/er.4563http://dx.doi.org/10.1002/er.4563.
HONG Liang. Design, preparation and temperature effect of β-radiation photovoltaic isotope battery[D].Nanjing: Nanjing University of Aeronautics and Astronautics, 2015.
Wrbanek J D, Wrbanek S Y, Fralick G C. Micro-fabricated solid-state radiation detectors for active personal dosimetry[Z]. NASA/TM-2007-214674, 2007: 1-17. 10.2514/6.2007-5596http://dx.doi.org/10.2514/6.2007-5596
ICRP. Radionuclide transformations - energy and intensity of emissions[M]. London: PERGAMON PRESS LTD, 1983.
Klein C A. Bandgap dependence and related features of radiation ionization energies in semiconductors[J]. Journal of Applied Physics, 1968, 39(4): 2029-2038. DOI: 10.1063/1.1656484http://dx.doi.org/10.1063/1.1656484.
Green M A. Solar cells: operating principles, technology, and system applications[M]. Englewood Cliffs, NJ: Prentice-Hall, 1982.
刘玉敏. β辐射伏特效应微型核电池的研究[D]. 长春: 吉林大学, 2018.
LIU Yumin. Study on β radiation volt effect micro-nuclear battery[D]. Changchun: Jilin University, 2018.
LIU Yunpeng. Design, fabrication and environmental factors of beta radiation volt effect isotope battery[D].Nanjing: Nanjing University of Aeronautics and Astronautics, 2014.