RADIATION GRAFTING OF DEGDMA AND HEMA ONTO SILLICON RUBBER BY DIRECT METHOD
|更新时间:2023-04-23
|
RADIATION GRAFTING OF DEGDMA AND HEMA ONTO SILLICON RUBBER BY DIRECT METHOD
Journal of Radiation Research and Radiation ProcessingVol. 2, Issue 1, Pages: 27-31(1984)
作者机构:
1.上海科学技术大学
作者简介:
基金信息:
DOI:
CLC:
扫 描 看 全 文
Du Cong, Li Zunling, Lu Wei, et al. RADIATION GRAFTING OF DEGDMA AND HEMA ONTO SILLICON RUBBER BY DIRECT METHOD. [J]. Journal of Radiation Research and Radiation Processing 2(1):27-31(1984)
DOI:
Du Cong, Li Zunling, Lu Wei, et al. RADIATION GRAFTING OF DEGDMA AND HEMA ONTO SILLICON RUBBER BY DIRECT METHOD. [J]. Journal of Radiation Research and Radiation Processing 2(1):27-31(1984)DOI:
RADIATION GRAFTING OF DEGDMA AND HEMA ONTO SILLICON RUBBER BY DIRECT METHOD
This paper mainly reports the γ-induced radiation grafting of diethylene glycol dimethacrylate (DEGDMA) and its mixture with ,β,-hydroxyethyl methacrylate (HEMA) in ethanol/water (1:1,W,/,W,) systems onto silicon rubber by direct method.,The results show that the grafting yield is increased with the radiation dose, and concentration of monomer and the concentration of transfer agent in systems.,When the concentration of cu,++, ions reached 0.075,N, a maximum graftion yield was observed.,At the same radiation dose, the degree of grafting decreased with the increase of dose rate. However, at the same dose rate, the grafting level increased with dose.,The water content in grafts increased with the concentration of hydrophilic HEMA in the mixture of monomers.,It is advantageous to increase the grafting level in ethanol/water (1:1 ,W,/,W,) by increasing the concentration of hydrophobic DEGDMA.
Photo-isomerization of 4-[4-(acryloyl)phenylazo]benzene sulfonic acid and hydrogel prepared with photo-polymerization
Preparation of CS/PAAc copolymer hydrogel with irradiation method and characterization of its swelling properties
Radiation polymerization and controlled drug release of P(NIPA−co−HEMA) and PNIPA/P(HEMA) IPN hydrogels
Related Author
No data
Related Institution
Key Laboratory of Carbon Fiber and Functional Polymers, Ministry of Education, College of Material Science and Engineering, Beijing University of Chemical Technology
Changzhou Institute of Advanced Materials, Beijing University of Chemical Technology
Department of Chemical Engineering and Technology, School of Environmental and Chemical Engineering, Shanghai University (Jiading Campus), Jiading
Department of Electronic Information Materials, School of Materials Science and Engineering, Shanghai University (Yanchang Campus), Yangchang Road
College of Materials Engineering, Zhengzhou University